Disconnect power. To allow communication between the controller and module, move the bus lever fully to the left 4 until it clicks. Ensure it is locked firmly in place. Attach an end cap terminator 5 to the last module in the system by using the tongue-and-groove slots as before. Lock the end cap bus terminator 6.
|Published (Last):||14 February 2007|
|PDF File Size:||6.74 Mb|
|ePub File Size:||16.74 Mb|
|Price:||Free* [*Free Regsitration Required]|
Route the wire under the terminal pressure plate. Loosen the terminal screws to be wired. Host Controller Spacing for single-wide modules 35 mm 1. Approximate Shipping Weight with carton g 0. Attach an end cap terminator 5 to the last module in the system by using the tongue-and-groove slots as before. Lock the end cap bus terminator 6. Overall hole spacing tolerance: Mounting screws are required on every module.
This lets you individually cancel each low process alarm i8f. Tell us about it. Locate holes every However, some systems, like the ADN DeviceNet Adapter, also allow the bits to be altered as part of the control program, using communication rungs.
Rockwell Automation Support Rockwell Automation provides technical information on the web to assist you in using our products. Use a power supply that matches the input transmitter specifications. Your markings ID tag will be visible when the module door is closed. Ensure it is locked firmly in place. In that case, graphical screens are provided by the programmer to simplify configuration. To allow communication between the controller and module, move the bus lever fully to the left 4 until it clicks.
The terminal screws are non-captive. The latches will momentarily open and lock into place. NC Wiring for channels are identical. Remove the label from the door, mark the identification of each terminal with permanent ink, and slide the label back into the door.
Replacing a Single Modu le within a System Your manual failed to upload Input Data File Word For each input module, slot x, words in the input data file contain the analog values of the inputs. The terminals will accept a 6. Most Related.
8 Universal Analog Inputs
Rockwell Automation Allen-Bradley 1769-IF8 Manuals
Rockwell Automation Allen-Bradley 1769-OF8C Manuals
Rockwell Automation 1769-IF4 User Manual